Vaporesso XROS 6 Pod System Kit 1800mAh VENTURI

8.000 KD

The Vaporesso XROS 6 is the most complete device in the standard XROS line — 1800mAh of battery, a colour screen with a proper menu, and two genuinely useful new systems for airflow and leak prevention.

VENTURI Airflow for a Smoother Draw

The new VENTURI airflow system reshapes how air moves through the device, producing a noticeably smoother, less turbulent draw than earlier XROS models. Paired with the side airflow switch, you can dial the draw from tight MTL to open RDL without pulling the pod out.

SSS 2.0 and 60s Smart Prime

SSS 2.0 is the upgraded anti-leak structure, and it addresses the single most common complaint about pod systems. Alongside it, 60s Smart Prime fully saturates a fresh coil in one minute — no more waiting ten minutes after a pod swap and hoping you did not rush it.

Charge in a Coffee Break

The XROS 6 accepts 9V/2A or 5V/3A charging and reaches roughly 50% in ten minutes. With 1800mAh behind it — a clear step up from the 1500mAh XROS 5 — running flat becomes a rare problem.

Screen, Controls and Pod

The 0.88″ TFT colour screen carries an expanded menu with more settings than the XROS 5 offered, and the device fires by draw or by button as you prefer. The 3ml pod supports the full 0.4ohm to 1.2ohm range on COREX 3.0 heating. At 122 × 24.5 × 14.5mm it stays comfortably slim.

Who Should Buy It

Pick the XROS 6 if you want more battery than the XROS 5, the smoothest draw in the family, and the strongest leak protection Vaporesso has fitted to an XROS. Step up to the Pro 2 only if you need 2000mAh and a bigger screen.

Available at GSVAPING for 8.000 KWD.

Have a question?

Categories: , Brand:

Technical Specifications

Battery and Charging

  • Built-in battery capacity: 1800mAh
  • Charging port: USB Type-C
  • Charging input: 9V/2A or 5V/3A
  • Approximately 50% charge in 10 minutes

Power and Output

  • Maximum output: 30W

Display and Controls

  • 0.88″ TFT colour screen
  • Expanded settings menu
  • Firing modes: draw-activated and button-activated

Pod and Coils

  • Pod capacity: 3ml
  • Supported resistances: 0.4ohm to 1.2ohm
  • COREX 3.0 heating technology
  • SSS 2.0 upgraded anti-leak structure
  • 60s Smart Prime coil saturation

Airflow

  • VENTURI airflow system
  • Side airflow switch

Dimensions

  • 122 × 24.5 × 14.5mm

Compatible Pods & Coils